Operation Manual

Thermostatic radiator valve | 21
EN
(Re)Calibrate the thermostatic radiator
valve
Calibration happens automatically during
the start up. It can also be forced:
Web interface Adam HA:
• Go to Setup via the menu.
• Go to the thermostatic radiator valve
and click below Device information on
More.
• Click on Calibrate.
Push button:
• Press the button for 10 seconds and
release.
• Within 1 second, press the button
again for 10 seconds and release,
• Within 1 second, press the button for
3 seconds and release. The LED will
blink orang slowly until the calibration
is completed.
After completion, the LED will blink for 5
seconds:
» Orange-green if the calibration was
successful.
» Orange-red if the calibration has failed
.
Calibration does not succeed if the
thermostatic radiator valve is not
connected to the radiator. This goes
wrong because the radiator valve
cannot determine a xing point.