Operation Manual

18 | Thermostatic radiator valve
Floor
• Connect the adapter cable to the USB
adapter and plug the adapter into the
wall socket. Floor will start calibrating.
Tom
Please decide if you want to power up Tom
using an USB adapter or batteries.
• Remove the cap of Tom in order to
place the batteries or USB adapter.
Hold the white adapter ring rmly in
place and pull the cap from Tom.
USB adapter
• Place the adapter cable into Tom.
Make sure you will direct the cable
through the opening as shown in the
image
• Put back the cap on Tom.
• Connect the adapter cable to the USB
adapter and plug the adapter into the
wall socket. Tom will start calibrating.
Batteries
• Place the batteries into Tom. Make
sure the batteries are placed as
indicated in the battery compartment
of Tom. If the batteries are installed
correctly, Tom will start calibrating.
opening
2. Connect the power supply