Operation Manual

16 | Thermostatic radiator valve
Installation
1. Mount the thermostatic
radiator valve on to the
radiator
• First, make sure the valve pin is fully
retracted. This is required for the
installation of the thermostatic
radiator valve.
Zigbee network
Floor is powered by a USB adapter. Tom
can be powered with both batteries or a
USB adapter. Depending on which one you
choose, Tom will automatically adapt its
behaviour when joining a new network.
If you install the thermostatic radiator
valve with an USB adapter, it is
permanently powered. The radiator valve
will behave like a “Zigbee Router” (ZR). The
radiator valve is now always available for
other Zigbee modules and increases the
quality of the Zigbee network.
Do you want to install Tom with batteries?
That is also possible. Tom is set to a power
saving “sleep” mode, so that less power is
used. Tom will behave like a “Zigbee End
Device” (ZED) in the network.
Zigbee router
Zigbee end device
Zigbee gateway
 internet
valve pin retracted
valve pin extended
Is the valve pin not fully retracted?
First power up the thermostatic
radiator valve as described on page
18. When powering the
thermostatic radiator valve, it will
start calibrating. The valve pin will be
retracting and then extending.