Operation Manual

11
1. Adding the Switch to your
Plugwise network
Ì InstallthetwoAAAbaeriesintheSwitch.Notethe+and-marks.
Only install the baeries if you are about to connect the Switch to the
Plugwise network. As long as the Switch is not connected to a network, it
will consume more power.
Ì Thetwoarrowsontheinsideof thebackplateindicatethetop.
Ensurethatthe|markoftherockerwillbeatthetop.Clicktherocker(s)
ontothebackplate:
Note: donotinstallthesurroundyet!
Ì StartSourceandselectSengs,AddModules.
Ì When you are asked to select a network,select the networkto
whichtheSwitchmustbeadded.
Ì FillintheIDoftheSwitch.Thisisshownonthesckersthatare
aachedtotheback.
Ì Clickthebuonwiththegreenarrow:
IfyouwanttoinstallmulpleSwitches,addtheIDsforalloftheSwitches
tothelist.ThePlugwisenetworkwillthensearchfortheSwitcheswith
thenewIDsinthelist.
Ì BrieypressoneoftherockersoftheSwitcheveryapproximately10
seconds,unlSourceshowsthatitisonline.Thecirclewiththequeson
markwillthenchangeintothefollowingpictogram:
If the Switch is not found within several minutes, check whether the