Installation Instructions

Adam | 25
EN
I cannot get Adam connected to the wi
network, what to do?
• First connect Adam to your router
with a LAN cable.
• Power up Adam and wait until Adam
has booted up: the
light is on and
the
light is blinking. Adam is now
connected to the network.
• Open the local web interface:
» go to connect.plugwise.net
» log in with the ID of Adam.
» enter smile as user name and use the
ID as password.
• Go via the menu to Settings > System >
Network.
• Press Scan networks. Select the wi
network you want to connect Adam
with and enter the password. Save
your settings.
• Remove the LAN cable as soon as is
indicated in the web interface.
Is Adam still working if there is no
internet?
Adam continues to work for you, even if
the internet connection has been lost. You
can’t use the app now to set the
temperature. You can reach the web
interface though, but only via the IP
address of Adam within your own network.
Do you want to set another temperature?
You can do this using the thermostat.
Issues with the local web interface
Why is it not possible to open the local
web interface?
Make sure your device, on which you want
to open the web interface, is connected to
the same network as Adam is connected
to.
What I see in the local web interface
does not match the current settings,
what to do?
Remove the cache from the browser and
open the page again and/ or try to open
the web interface via an incognito window
in the browser.
Issues with the app
The app is not always working or is very
slow, what to do?
You need a good internet connection if you
want to use the app. Did you connect
Adam to a wi network? Check the quality
of the network connection at Settings >
System > Network.
» -30 dBm: excellent
» -67 dBm: very good
» -70 dBm: moderate (min. signal strength)
» -80 dBm: not good (unreliable)
» -90 dBm: not usable