Installation Instructions

20 | Adam
Adam wi network (see also page
18)!
• Go via the menu to Settings > Heating
system > Boiler. Check if the protocol
of the boiler is recognized (on/off or
OpenTherm), see image. Not the right
boiler protocol or is there no boiler
protocol detected? Check whether
you have connected Adam correct to
the boiler.
If correctly installed, restart the boiler
and Adam in case of an OpenTherm
boiler. Connected to an on/off boiler?
Click Update boiler protocol.
• Go via the menu to Settings > Heating
system > Heating. Here you can turn
on the Plugwise regulation. You have
to turn on the Plugwise regulation if
you have installed zone heating.
Save your settings.
• Go via the menu to Settings > Heating
system > Heating. Enter the details
about your heating system below the
heading Installation. The Plugwise
regulation will use these to heat up
your house as optimal as possible.
Save your settings.
2. Connect to the boiler