Installation Instructions

Adam | 19
EN
Installation with Opentherm thermostat
20,5°
20,5°
20,5°
Installation with zone thermostat Lisa
20,5°
20,5°
20,5°
Installation with thermostat Anna
(OpenTherm)
20,5°
20,5°
20,5°
Consult the manual of the boiler for
more information about the
connector of the boiler.
• Unplug the boiler and Adam from the
electrical power.
• Disconnect the thermostat wire
between the boiler and the
thermostat at the boiler boiler end of
the wire and connect the installation
cable with Adam at the boiler icon
.
• Connect the wire running to the
thermostat with the installation cable
at Adam with the thermostat icon
.
This is not necessary if you install Adam
without an OpenTherm thermostat but with
zone thermostat Lisa.
• Determine the position of Adam near
the boiler and mount the wall plate of
Adam to the wall.
• Click Adam onto the wall plate.
• Connect both the boiler and Adam to
the power outlet and wait until Adam
has started up: the upper
light and
light in the middle are blinking
slowly (Adam is in acces point mode).
• Open the local web interface of Adam
in the web browser of your device
(setup.now or 192.168.40.40). Make
sure you are still connected to the
2. Connect to the boiler