User Manual
20 Appendix
(PL2) Synthesizer - English Manual
Appendix 21
(PL2) Synthesizer - English Manual
+--------------------+-------------+-------------+--------------------------------------+
| Function | Transmitted | Recognized | Remarks |
+--------------------+-------------+-------------+--------------------------------------+
|Program | x | o 0-63 | |
|Change True Number |*************| 0-63 | *9|
+--------------------+-------------+-------------+--------------------------------------+
|System Exclusive | x | o | *10|
+--------------------+-------------+-------------+--------------------------------------+
|System SongPosition| x | x | |
|Common SongSelect | x | x | |
| Tune | x | o | *11|
+--------------------+-------------+-------------+--------------------------------------+
|System Clock | x | o | *12|
|Real Time Commands| x | o Start | *13|
+--------------------+-------------+-------------+--------------------------------------+
|Aux :Local On/Off | x | x | |
|Mes- :All Notes Off| x | o 1-127 | |
|sages :Active Sense | x | x | |
| :Reset | x | o | *14|
+--------------------+-------------+-------------+--------------------------------------+
+--------------------+-------------+-------------+--------------------------------------+
|Notes |
| *1: Switch |
| *2: Pitch Wheel Change (E0 hex). MSB and bit 0 of LSB used |
| *3: Effects parameters according to bitpattern table (dened in controller #31, 82) |
| *4: Overwrites Aftertouch information and vice-versa |
| *5: Overwrites PWM 1 (controller #25, 76) and PWM 2 (controller #23, #95) |
| *6: Effective only for waveform 2-4 (controller #24, 75) |
| *7: Denes modulation wheel routings according to bitpattern table |
| *8: Controller #89 sets both, Aftertouch (bit 5) and Note Priority (bit6) |
| *9: 0-31 (program 1-32) is xed factory set, 32-63 (program 33-64) is user set |
|*10: Used for future system exclusive rmware updates |
|*11: Reset to start-up condition |
|*12: Synchronising LFO clock and ADSR speed. Once linked a loosing clock signal will |
| cause a complete system reset! |
|*13: LFO restart |
|*14: Reset to start-up condition |
+---------------------------------------------------------------------------------------+
Mode 1 : OMNI ON, POLY Mode 2 : OMNI ON, MONO o :Yes
Mode 3 : OMNI OFF, POLY Mode 4 : OMNI OFF, MONO x :No
2120