SDS

US GHS: The exact percentage (concentration) of composition has been withheld as a trade
secret in accordance with paragraph (i) of §1910.1200.
*CANADA GHS: The exact percentage (concentration) of composition has been withheld as a trade
secret.
Composition comments
4. First Aid Measures
If symptoms develop move victim to fresh air. If symptoms persist, obtain medical attention.
Inhalation
IF ON SKIN: Wash with plenty of water. If skin irritation occurs: Get medical advice/attention. Take
off contaminated clothing and wash it before reuse. Specific treatment (see information on this
label).
Skin contact
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present
and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
Eye contact
Rinse mouth. Do not induce vomiting. If vomiting occurs naturally, have victim lean forward to
reduce risk of aspiration. Never give anything by mouth if victim is unconscious or is convulsing.
Get medical attention if symptoms occur.
Ingestion
Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Skin irritation. May
cause redness and pain.
Most important
symptoms/effects, acute and
delayed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved and take precautions to
protect themselves. If you feel unwell, seek medical advice (show the label where possible). Show
this safety data sheet to the doctor in attendance. Avoid contact with eyes and skin. Wear rubber
gloves and chemical splash goggles. Keep out of reach of children.
General information
5. Fire Fighting Measures
Dry chemical powder. Carbon dioxide. Water Fog.
Suitable extinguishing media
None known.
Unsuitable extinguishing
media
Firefighters should wear a self-contained breathing apparatus.
Specific hazards arising from
the chemical
Firefighters should wear full protective clothing including self-contained breathing apparatus.
Special protective equipment
and precautions for firefighters
In the event of fire, cool tanks with water spray. Cool containers with flooding quantities of water
until well after fire is out.
Fire-fighting
equipment/instructions
Cool containers exposed to flames with water until well after the fire is out.
Specific methods
May include and are not limited to: Oxides of carbon. Oxides of sulfur.
Hazardous combustion
products
6. Accidental Release Measures
Keep unnecessary personnel away. Keep out of low areas. Keep people away from and upwind of
spill/leak. Use a NIOSH/MSHA approved respirator if there is a risk of exposure to dust/fume at
levels exceeding the exposure limits. Wear appropriate protective equipment and clothing during
clean-up. Do not touch damaged containers or spilled material unless wearing appropriate
protective clothing. Avoid inhalation of dust from the spilled material. Ensure adequate ventilation.
Local authorities should be advised if significant spillages cannot be contained. For personal
protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Absorb spillage to prevent material damage. If sweeping of a contaminated area is necessary use
a dust suppressant agent which does not react with the product. Collect dust using a vacuum
cleaner equipped with HEPA filter. Avoid dust formation. Minimize dust generation and
accumulation. Prevent entry into waterways, sewer, basements or confined areas. Following
product recovery, flush area with water. Sweep up or vacuum up spillage and collect in suitable
container for disposal. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and Storage
Minimize dust generation and accumulation. Provide appropriate exhaust ventilation at places
where dust is formed. Use only with adequate ventilation. Avoid breathing dust. Avoid prolonged
exposure. Avoid contact with clothing. In case of insufficient ventilation, wear suitable respiratory
equipment. Wear appropriate personal protective equipment. Wash thoroughly after handling. Do
not get in eyes, on skin or on clothing. Use good industrial hygiene practices in handling this
material. Keep container tightly closed.
Precautions for safe handling
#25894 Issue date 11-April-2018
Page: 2 of 7