PLEN Cube with Bluetooth and WiFi : Instruction Manual : Page 6

2. For the first time use or when the PLEN Cube is not connected to any network, the

PLEN Cube will start-up in “Hotspot Mode.” From Hotspot Mode, please follow the

following steps to connect to a new network.

3. The PLEN Cube creates its own limited WIFI network while on HotSpot Mode. On the

smartphone, tablet, or PC device, please open the list of available WIFI networks and

change the current network to the hotspot created by the PLEN Cube beginning with

< plencube… >. When asked for a password, please input the security key

< plencube > . (※)

※Password should be entered without the angle brackets “<” and “>”

4. While connected to the “plencube...” hotspot network, open a web browser (Google

Chrome recommended) and enter the hotspot IP address of the cube: 【 10.42.0.1 】

and the network connection screen for the PLEN Cube will be displayed.

When the PLEN Cube has successfully connected to the entered network, it will voice

the name of the network it has connected to and follow by voicing its new IP address

within this network. Please note this new IP address voiced by the PLEN Cube

and do not lose it.

The complete functionality of the PLEN Cube cannot be used until the user

registration has been completed.

※ In the event the voiced IP address was lost or misunderstood, please turn off the PLEN Cube by

pressing and holding the power switch for 5 full seconds and then turn the PLEN Cube back on by

holding the power switch for 3 full seconds. During this new start-up, the PLEN Cube will again voice

the network name and IP address it is currently connected to. It is important to take note of this voiced

network and IP address to connect to the PLEN Cube.

※ If the PLEN Cube voices the hotspot network and IP address, or starts up in Hotspot Mode after

turned on, the connection to the networks known by the PLEN Cube has failed. This procedure to

connect to a network from the PLEN Cube hot spot must be repeated.

※ Please conduct the network connection procedure in a location to the WIFI network where the

6