Instruction Manual

【 Charging the PLEN Cube 】
Before turning the PLEN Cube on please completely charge the battery. Insert the
USB micro-B connector side of the charging adapter in the proper orientation into the
charging terminal located on the back of the bottom half of the PLEN Cube.
※ Please charge the PLEN Cube using only the provided charging adapter
※ If the adjacent status LED light is flashing red , immediately remove the USB connector
from the terminal and stop using it.
【 First-time Operation 】
A smartphone, tablet, or computer is required for initial setup.
< Network setup >
This section will describe how to connect the PLEN Cube to a local WIFI
network.
The PLEN Cube will automatically try to connect to the most recently setup
network proceeding the initial operation and setup. The PLEN Cube will voice
its IP address of the current connected network during start-up. If the PLEN
Cube cannot recognize or connect to any available networks, the network setup
procedure must be conducted again.
Please follow the described steps whenever connecting to a new network.
1. Turn on the PLEN Cube by pressing and holding the power switch button, located on
the back of the bottom half of the PLEN Cube, for 3 full seconds. When the start-up
procedure begins, the front white LED light will turn on for a short time. Please wait
approximately 1 minute for the start-up process to fully complete.
For the first time start-up, the PLEN Cube will be in hotspot mode and the fixed IP
address will be 【 10.42.0.1 】
When the PLEN Cube is connected to a network, it will voice its IP address within that
connected network, which may differ between different networks.
5