Full Product Manual

LEG INSTALLATION (If required)

Before Installing Heater, Follow These Steps for leg Installation.

2. With assistance, carefully place stove on its top onto the padded surface.

3. Insert the holes of a leg into the two (2) Threaded Studs shown in Figure 0.1.

4. Tighten the nuts securely (DO NOT over tighten) to the Threaded Studs.

5. Repeat steps 3-4 to install the other three (3) legs.

6. With assistance, lift the stove off of the padded surface, and set upright onto the newly installed legs.

Nut

Threaded Studs

BATTERY INSTALLATION

Step 1 – Locate the Push Button Ignitor by lowering the cover on the bottom of the stove. (Fig. 1)

(Fig. 2)

Step 3 – Insert the battery with the positive (+) side facing forward.

Push Button Ignitor

Cover

Push Button

Ignitor

Push Button

Cap

AAA Battery