Installation Guide

6
5. While keeping the door panels fully open,
place the Glass Door against the replace.
Place the “T” head of the Key Bracket (E) into
the slotted bracket on the back of the door as
shown in the inset and turn bracket assembly
to horizontal position as shown in Figure 5.
Repeat on opposite end.
6. Center the Glass Door against the replace
opening. (A second person may be
necessary to hold the door tightly against the
replace opening.) Reach inside and slide the
Lintel Clamp (D) back or forward until the lip
of the Lintel Clamp (D) is rmly against the
lintel bar. Tighten the 1/4-20 x 1/4” Machine
Screw (A). Making sure the Glass Door is
against the replace, tighten the 1/4-20 x 2”
Thumbscrew (C) until the door is secure on
top as shown in Figure 6.
Repeat on opposite end.
7. Insert 1/4-20 x 3 1/2” Thumbscrew (I) into
Pressure Bracket (H). Insert Pressure Bracket
(H) into the pair of holes closest to the side
of the replace opening. Making sure the
Thumbscrew (I) is pointing towards the
sidewall of the replace, tighten the Thumb-
screw (I) into the wall. Repeat on opposite end.
INSTALLATION INSTRUCTIONS
7
6
5
C
Bracket
Assembly B
Bracket
Assembly A
E
H
I
D
A