Full Product Manual

9
INSTALLATION INSTRUCTIONS
8. There are four door panel hinges (two in
the top track and two in the bottom track).
The door panel hinges are designed to be
adjusted. If the door panels are not evenly
aligned or if there is too much space
between the center of the door panels
(when they are in a closed position), you
may adjust them as follows:
Open the door panels. Reach inside and
loosen the panel hinge screws. Do not
remove the screws. Slide the door panel
hinges left or right until the space between
the center of the door panels is even, as
shown in Figure 8.
Return door panels to their original
position.Carefully maintain the door panel
hinge position and tighten screws.
9. To remove the door panels for cleaning or
replacement, begin by opening the door
panels. Remove the door panel hinge
screws from the top and bottom hinges
as shown in Figure 9. Remove the door
panel(s).
Door Hinge
Door Hinge
8
9
NOTE: In some models, a riser bar is provided with two sets of holes (top and bottom). For
proper flush fit, use the top or bottom set of holes, whichever are suitable to your frame.
Remember that proper flush means the back edges of the riser bar and the back edges of the
bottom frame assembly are even. In some cases, the riser bar will extend in front of the frame
assembly, which is correct.