Technical Specifications

13
Note: Quantities will vary depending on the
materials used to build the A-Frames.
A-Frame Assembly
Follow Pages 13-16
Items for STEP 1:
Install Sturdy-Frame Brackets onto separate 4" x 4" boards. (Brackets
are stamped R and L)
Position bracket flat on a 4" x 4" board as shown. Slide bracket over
and down until it stops against the top and the side of the 4" x 4"
board. When correctly positioned, the edge of the Sturdy-Frame
Bracket will be parallel with the edge of the 4" x 4" board. Attach
bracket with #8 x 1¹⁄₄" deck screws.
Using the Sturdy-Frame Bracket as a drill guide, drill two ³₈" holes
through the 4" x 4" board. Secure with two ³₈" x 4" hex bolts with
³₈" washers and lock nuts.
Repeat for each assembly.
Left-hand
Right-hand
Stop
Stop
Stop
Stop
Rear View of bracket and
post assembly showing
correct position.
Rear View of bracket and
post assembly showing
correct position.
4 ' x 4 ' Post
Extend-A-Bay Swing Station
3 Post 5 Post
(3) or (5) 4" x 4" x 96" boards
(2) or (5) Sturdy-Frame Brackets
(4) or (10) ³₈" x 4" hex bolts
(8) or (20) ³₈" washers
(4) or (10) ³₈" lock nuts
(4) or (10) #8 x 1¹⁄₄" deck screws
Free-Standing Swing Station
(4) 4" x 4" x 96" boards
(3) Sturdy-Frame Brackets
(6) ³₈" x 4" hex bolts
(12) ³₈" washers
(6) ³₈" lock nuts
(6) #8 x 1¹⁄₄" deck screws
Caution: Make sure bolts are tight and the threads of each bolt are at least
flush to the end of the nut to ensure proper engagement.
Note:
If your
lumber is
oversized,
counterbor-
ing may be
required.