Instuctions

Wire 1 2 3 4 5 6 7 8
T568A White/Green Green White/Orange Blue White/Blue Orange White/Brown Brown
T568B White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown
6) Roll up the drain wire and
place in the base of the
external ground. As you start
to bring the external ground
into place onto the cable, keep
the mass of drain wire tucked
in so it is totally covered.
7)
Crimp the
external ground
using the CT-360.
Use the large or small
tool cavity depending
on the size of your cable.
NOTE: DO NOT
over crimp
the external
ground.
Bend down the external ground
onto the cable jacket and push
in the wing tips.
8)
Large Cavity
Small Cavity
9) Youarenished.Jobwelldone!
10Gig Termination Kit Instructions
www.platinumtools.com
©2014 Platinum Tools Inc. All rights reserved. TS 2/14
3) Reshape the
end of the cable
using the CT-360
(PN 12360),
making it oval
so it slides into
the connector
with ease. Your wire is ready to be inserted.
Insert the
prepped
connector into
the proper cavity
of the Tele-TitanXg
(P/N 12515C) crimper,
Squeeze handle to
terminate.
5)
2) Line up your wires
and make a clean
cut across all
8 conductors and slide
on the wire guide bar.
(A) Slide bar down toward end of jacket and stop when
3/16" away from the end.
(B) Flush cut across all 8 conductors at the front end of the bar.
4) Carefully insert into backend of connector (A) and push
all the way forward (B) until all 8 conductors are seated
 ushagainstthefrontend.
NOTE: DONOTuseastandardRJ45crimptool.Thisconnector
is designed with NO primary strain relief. Using a
 standardRJ45crimptoolwillcrushtheconnector.
A B
1) Strip & remove 1" of your cable
jacket with the Cyclops
®
2 Cable
Stripper (P/N 15010C). Remove
cellophane and shield. Straighten
the wires.
Determine whether
you will be using
the T568A or T568B
conguration(above)
and organize wires
accordingly.
B
A