User Manual
California, USA
www.platinumtools.com
We Make Connections EZ!
™
2018© Platinum Tools, Inc. All rights reserved.
Waterproof RJ45 Bulkhead Coupler Instructions
INSTRUCTIONS (The RJ45 Connector Requires this Prep)
1. Slide screw nut over backend of housing until it stops at the ange.
2. Insert seal into clip.
3. Insert the clip & seal assembly into the backend of the housing until
fully seated.
4. Screw sealing nut onto the backend of the housing and STOP at the
point of feeling some resistance from the gasket.
5. Housing assembly is now ready for the cable. Insert cable through the
backend and slide down, leavin enough cable to prep and terminate the
RJ45 connector.
6. Once RJ45 is terminated, slide the housing assembly up to the backend
of the RJ45.
7. Rotate RJ45 until the locking tab is in the center of the alignment pins.
8. Squeeze locking tab and insert RJ45 until fully seated.
9. Secure cable by turning sealing nut until tight at the backend of the
housing assembly.
10. Remove adhesive backing from the gasket. Push screw nut back. Apply
gasket to housing using the RJ45 nose prole as a guide. Be sure
adhesive is facing housing.
#6
#2
#1
#10
COUPLER INSTRUCTIONS
1. Place rubber gasket on the end.
2. Insert from inside to out through hole in panel/box.
3. Slide waterproof cap ring over exposed end.
4. Screw down on plastic nut and cinch down.
DO NOT OVER TIGHTEN
RECOMMENDED PANEL CUT
19.4mm x 20.8mm
(0.760” x 0.815”)
P/N 741C