User Manual

California, USA

www.platinumtools.com

We Make Connections EZ!

™

Waterproof RJ45 Splice Coupler Instructions

INSTRUCTIONS (EACH RJ45 Connector Requires this Prep)

1. Slide screw nut over backend of housing until it stops at the ange.

2. Insert seal into clip.

3. Insert the clip & seal assembly into the backend of the housing until

fully seated.

4. Screw sealing nut onto the backend of the housing and STOP at the

point of feeling some resistance from the gasket.

5. Housing assembly is now ready for the cable. Insert cable through the

backend and slide down, leaving enough cable to prep and terminate

the RJ45 connector.

6. Once the RJ45 is terminated, slide the housing assembly up to the

backend of the RJ45.

7. Rotate RJ45 until the locking tab is in the center of the alignment pins.

8. Squeeze locking tab and insert RJ45 until fully seated.

9. Secure cable by turning sealing nut until tight at the backend of the

housing assembly.

10. Remove adhesive backing from the gasket. Push screw nut back. Apply

gasket to housing using the RJ45 nose prole as a guide. Be sure

adhesive is facing housing.

11. RJ45 #1 is ready. Now repeat and prep RJ45 #2.

#10

NOTE: 2 EA RJ45 CONNECTORS REQUIRED (NOT INCLUDED)

P/N 740C