Spec Sheet

We Make Connections EZ!
™
Specications subject to change without notice.
www.platinumtools.comwww.platinumtools.com
California, USA
Phone: [phone].749.5783
•
Fax: [phone]
©2019 Platinum Tools, Inc. All Rights Reserved. PoE+10Gig Shielded RJ45 Field Plug 190606 BM
PoE+ 10Gig Shielded RJ45 Field Plug
Instructions
If needed cut off part of the strain relief to fit the
cable. Then thread the cable through the strain
relief.
1
Strip off 2” of the cable jacket and fold any braid over the
jacket. Wrap the drain wire around the cable
jacket and cut off any mylar/cellophane, cable foil
and the pair separator spline if applicable.
2
Determine your choice of either T568A or T568B
wire configuration (see above chart) and position all
4 pairs, making ready for placement in the wire tray.
Peel the foil from the outer pairs (1/2, 7/8) down to
the jacket. With the inner pairs (3/6, 4/5), leave 1/2”
of foil on the pairs. Do not separate the wires yet.
3
4
Pinch the inner pairs (4/5, 3/6) together to thread
through the wire tray.
5
Thread the inner pairs (4/5, 3/6)
through the wire tray
and seat the wires in the proper
slots as shown below. Then
route the outer pairs on top of
the wire tray and seat the wires
as shown. Once the wires are
pressed into the slots, trim the
excess wires with a pair of
flush-cutters.
6
7
8
Flip the wire tray upside down
and insert it into the connector
pressing it firmly into place.
Close the connector. The
halves should not have any
gaps between them. Use a
pair of parallel pliers if more
force is required.
Slide the strain relief up the
cable matching the word
“PoE+” on the same side of
the connector. Push the
strain relief and connector
together until the parts
click into place.
Wire 1 2 3 4 5 6 7 8
T568A White/Green Green White/Orange Blue White/Blue Orange White/Brown Brown
T568B White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown