Novaerus 600 Series Owners and Installation Manual

INTRODUCTION
The PlasmaPURE 600 is a brush-style
needlepoint ionizer producing positive and
negative oxygen ions that neutralize odors and
harmful pollutants. This unit is highly versatile
as it may be installed in a furnace, an air
handling unit, fan coil unit, PTAC, heat pump
or ductless split system. The unit is
self-contained in a potted ABS enclosure
which has molded tabs with mounting holes
for fan inlet mounting with screws or magnet.
Models are available to accept 12VDC,
24VAC, 120VAC and 230VAC without the use
of an external power supply.
ELECTRICAL INSTALLATION
WARNING: Do not connect to power
before installation is complete. Always
disconnect power to the unit before
handling the ionizer.
1. All field wiring to be in accordance with
NEC and Authorities Having Jurisdiction
(AHJ).
2. Connect power to ionizer using appropriate
voltage per the following: See figure 3.
601=12VDC, 602=24VAC, 603=120VAC,
604=230VAC
3. For 120VAC and 230VAC models the
installer shall provide a grounding method
per the local AHJ.
4. For best results interlock ionizer with
fan power.
5. Keep power wires away from tips of
brushes.
6. Apply power to unit. Green light indicates
the ionizer is functioning properly.
OPERATION
1. When power is supplied to the ionizer, the
ionizer will be activated and will illuminate
the green ion indicator light.
2. The ionization unit is self balancing and
does not require any type of adjustment.
TROUBLESHOOTING
If the unit is not working, check the following:
1. The supply fan is running and that the green
light illuminates.
2. Check the power input connections to the
ionization unit. Verify all connections are
correct and tightened. Reconnect any loose
wires as necessary.
MECHANICAL INSTALLATION
WARNING: Do not connect to power
before mechanical installation is
complete.
1. Mount unit downstream of the filter, for
best results avoid locations directly down-
stream of the cooling coil or a humidifier.
2. Mount unit at or near the fan inlet ensuring
air stream flows over the two brushes
simultaneously. See figures 1& 2.
3. Attach magnet to the sheet metal fan
housing. If using the mounting holes, ensure
the screws are not too long to avoid
interference with fan.
4. The tips of the brushes should be 1" away
from any metallic or grounded object.
(BLACK AC/RED DC)
(WHITE AC/BLACK DC)
MOUNTING
HOLES
PlasmaPURE
600 IONIZER
FUSE
CONNECT
TO POWER
FIGURE 3
FIGURE 2
FAN
DISCHARGE
FAN INLET
IN LINE 500 mA
GLASS CARTRIDGE FUSE
CONNECT
TO POWER
PlasmaPURE 600 IONIZER
MOUNTING HOLES
OR USE MAGNET
AIR FLOW
FIGURE 1
BRUSH
BRUSH
MAGNET
phone [phone]
fax [phone]
www.plasma-air.com
[e-mail]