7000 Series Submittal

PLASMA AIR 35 MELROSE PLACE, STAMFORD, CT 06902
PA-COM-US-SUB-011-REV2
phone [phone] fax [phone] www.plasma-air.com [e-mail]
© 2021 All rights reserved
SPECIFICATIONS:
Airflow Capacity: . . . . . . . . . . . . . . Up to 1.400 CFM (7100)
. . . . . . . . . . . . . . . . . . . . . . . 1.401 to 2,800 CFM (7200)
. . . . . . . . . . . . . . . . . . . . . . . 2,801 to 4,200 CFM (7300)
. . . . . . . . . . . . . . . . . . . . . . . 4,201 to 6.000 CFM (7400)
Pressure Drop: . . . . . . . . . . . . . . . . . Less than 0.01 In. WG
Housing Material: . . . . . . . . .18 Gauge steel powder coated
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 lbs
Maximum Operating Temperature: . . . . . . . . 200º F (93ºC)
Electrical:
Voltage . . . . . . . . . . . . . . . . . . . . 24V AC input (7XX1)
. . . . . . . . . . . . . . . . . . . . . . . 120V AC wall pack (7XX2)
. . . . . . . . . . . . . . .120V/240V AC power supply (7XX3)
. . . . . . . . . .277V AC to 12V DC power supply (7XX4)
Power Consumption: Less than 2VA per set of outputs
Current Draw: . . . . . . . . . . . . . . . . . 30 mA at 12V DC
Frequency: . . . . . . . . . . . . . . . . . . . . . . . . . . 50/60 hertz
Internal Fuse: . . . . . . . . . . . . . . . . . . . Auto reset 1 amp
BAS Monitoring: . . . . . . . . . . . . . Dry contact terminals
Ionization Output:
Mode of Operation: . . . . . . . . . . . . . . . . . . Needlepoint
Needle Configuration: . . . . . . . . . . . . . . . . . . .Recessed
No. of Ionization Modules: . . . . . . . . . . . . . . . . 1 (7100)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 (7200)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 (7300)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 (7400)
Plasma Air 7100 / 7200 / 7300 / 7400 IONIZATION PRODUCT SUBMITTAL
DIMENSIONS: See Figure 1
APPROVALS: UL2998, Intertek/ETL Standard UL 867
ORDERING NOMENCLATURE:
7XXX
1 – 24V AC from fan control terminals (standard)
2 – 120V AC to 12V DC wall pack
3 – 120V/240V AC to 12V DC inline power supply
4 – 241V/277V AC to 12V DC inline power supply
1 – up to 1,400 CFM
2 – 1,401 to 2,800 CFM
3 – 2,801 to 4,200 CFM
4 – 4,201 to 6,000 CFM
0 – Placeholder
The Plasma Air 7000 Series Models 7100 / 7200 / 7300 / 7400
needlepoint ionizers are rated up to 6000 CFM
and produce positive and negative ions
neutralizing harmful pathogens, pollutants and
odors. They are typically installed in supply ducts
utilizing the pre-drilled flange and factory applied
gaskets and can also be installed inside an HVAC
unit utilizing a contractor supplied mounting
bracket. The 7000 series is UL2998 validated for
zero ozone emissions.
TOP VIEW
SIDE VIEW BSIDE VIEW A
FIGURE 1
DIMENSIONS NOT TO SCALE
12V DC POWER
IN/OUT
DUCT CUTOUT DIMENSIONS
4
3
/4" × 4
3
/4" (7100/7200)
4
5
/8" × 8
3
/4" (7300/7400)
6
1
/2 " (7100/7200)
10
5
/8 " (7300/7400)
BAS MONITORING
DRY CONTACTS
1
/8" THICK NEOPRENE
SEALING GASKET
AROUND PERIMETER
IONIZATION
INDICATOR LIGHT
POWER
ON/OFF SWITCH
GASKETED
MOUNTING
FLANGE
4
1
/2" (7100/7200)
8
5
/8" (7300/7400)
3
1
/2"
1
1
/2"
6
1
/2"
AIR FLOW
FEEDBACK FUNCTIONALITY: The feedback
function provides an electronic signal only when the
ionizers are operating properly, i.e. when the ionizer is
creating ions. The products use this signal to power the
LED and initiate a relay that closes dry contacts.
All stated specifications are subject to change without notice or obligation.
4
1
/2"