INSTALLATION, OPERATION & MAINTENANCE MANUAL Plasma Air 7000 SERIES (MODELS 7100, 7200, 7300, 7400) REV 02/2021 www.plasma-air.
INTRODUCTION Plasma Air 7000 Series needlepoint ion generators are single outlet (7100), double outlet (7200), triple outlet (7300) and quad outlet (7400) commercial quality units intended for installation in air handling units (AHU), furnaces, or duct systems for commercial and residential applications. This ionization equipment is effective in reducing harmful pollutants and odors by introducing positive and negative ions into the system airflow.
ELECTRICAL INSTALLATION INSTRUCTIONS WARNING: Do not connect to power before the installation is complete. Always disconnect power to the unit before handling any of the unit components. The 7000 Series is compatible with a variety of primary voltage options. All models accept 24V AC or 12V DC. 12 VOLT DC POWER INPUT JACK (2.1mm pin) 1.
5. INSTALLING MULTIPLE UNITS: On systems where the airflow is over 6,000 cfm, multiple model 7300s or 7400s will be required. Wire them as shown below: 24V AC MODEL 7400 or 12V DC PSU MODEL 7400 PSU FIELD WIRING BY CONTRACTOR MODEL 7400 PSU WIRING BY PLASMA AIR OPERATION 1. When power is supplied to the ionizer and the switch is in the “on” position, the ionizer will be activated and will illuminate the green ion indicator light. (See figure 3) 2.
