Quick Start Guide

INTRODUCTION
Thank you for purchasing the PAX1800, a WiFi 6 AP.
This Quick Start Guide is designed to guide you
through the installaon process.
PACKAGE CONTENTS
1. Access Point
2. Mounng opons (ceiling, wall, pole, t-rail)
3. Closed cable housing lid
4. Screws and screw plugs for various surfaces
5. Cable es
https://www.plasma-cloud.com/product-detail/pax1800/
The last point can be repeated to add as many Access
Points as needed.
You can now plug-in your Access Point and connect it to
the Internet. The Plasma Cloud configuraon only takes
a few seconds!
CLOUD MANAGEMENT
1.
2.
3.
4.
5.
6.
Sign up at console.plasma-cloud.com.
Create your first organisaon by navigang to Organ-
isaons → Create new organisaon. Fill in the form
and click Create.
You can now create your first network. Navigate to
Networks → Create new network, fill in the form and
click Create.
Setup your network by navigang to Sengs →
Network.
Create and configure your first SSID by navigang to
Sengs → SSIDs → Create new SSID.
Go back to Overview and click on the map to add
your first Access Point.
21
PHYSICAL INSTALLATION
This Access Point is designed to be installed virtually
anywhere and can operate between 0°C ~ 40°C (32°F ~
104°F).
It comes with a set of mounng opons that can be used
to install this device on various surfaces such as: ceilings,
walls, poles and T-rails of various sizes.
This Access Point can be powered by:
1. a 12V/2A DC power adapter*
2. a 48-54V/0.5A PoE injector (802.3at)**
* The output shall comply with the requirement of SELV of IEC 60950-1 or ES1 of
IEC 62368-1 and in compliance with the requirements of limited power source of
IEC 60950-1 and IEC 62368-1. Connect dealer or distributor for standard PS.
** All ethernet cables are designed for intra-building connecon to other
equipment. Do not connect these ports directly to communicaon wiring or other
wiring that exits the building where the appliance is located.
WALL MOUNTING
1
Use the provided screws and
screw plugs to fix the mount-
ing plate on the wall.
2
Slide the Access Point over
the mounng plate.
3
Your Access Point is now safely
aached to the wall.
T-RAIL MOUNTING
1
Slide the T-rail mount into the
slot of the Access Point.
2
Hook the staonary end of the
mount bracket to the T-rail.
3
Your Access Point is now safely
clipped to the T-rail.
MOUNTING BRACKET OVERVIEW
US single
gang box
US double
gang box
EU/UK