Quick Start Guide
INTRODUCTION
Thank you for purchasing the PA2200. This Quick Start
Guide is designed to guide you through the installaon
process.
PACKAGE CONTENTS
1. Access Point
2. Mounng opons (ceiling, wall, T-rail)
3. Screws and screw plugs for various surfaces
4. Cable e
2.4GHz
5GHz
1
5GHz
2
The last point can be repeated to add as many Access
Points as needed.
You can now plug-in your Access Point and connect it to
the Internet. The Plasma Cloud configuraon only takes
a few seconds!
CLOUD MANAGEMENT
1.
2.
3.
4.
5.
6.
Sign up at console.plasma-cloud.com.
Create your first organisaon by navigang to Organ-
isaons → Create new organisaon. Fill in the form
and click Create.
You can now create your first network. Navigate to
Networks → Create new network, fill in the form and
click Create.
Setup your network by navigang to Sengs →
Network.
Create and configure your first SSID by navigang to
Sengs → SSIDs → Create new SSID.
Go back to Overview and click on the map to add
your first Access Point.
PHYSICAL INSTALLATION
This Access Point is designed to be installed indoor only
and can operate between 0°C ~ 40°C (32°F ~ 104°F).
It comes with a set of mounng opons that can be used
to install this device on various surfaces such as: ceilings,
walls and T-rails of various sizes.
This Access Point can be powered by:
1. a 54V/0.5A PoE injector (802.3af/at)
2. a 12/2A DC power adapter
SUPPORT
Feel free to visit hps://support.plasma-cloud.com for
addional technical guidance or to contact our support
department.
21
WALL MOUNTING
1
Use the provided screws and
screw plugs to fix the mount-
ing plate on the wall.
2
Slide the Access Point over
the mounng plate.
3
Your Access Point is now safely
aached to the wall.
2.4GHz
5GHz
1
5GHz
2
2.4GHz
5GHz
1
5GHz
2
T-RAIL MOUNTING
1
Slide the T-rail mount into the
slot of the Access Point.
2
Hook the staonary end of the
mount bracket to the T-rail.
3
Your Access Point is now safely
clipped to the T-rail.