User`s guide

Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set FlowCtrl to Enable for avoiding data transfer
overflow. Or it sets to Disable; there is either no flow control or other
hardware/software management.
When the 10/100M port is set to full duplex mode, then the flow
control will automatically set to disable; and if the 10/100M port is set
to half duplex mode, the flow control will automatically set to enable.
Bandwidth Control Ingress/Egress rate:
This Switch support the Port Bandwidth Rate Control, and will work
only on the auto mode.
VLAN Settings (Virtual Local Area Network)
A VLAN is a collection of switch ports that make up a single
broadcast domain. You can configure a VLAN for a single switch, or
for multiple switches. When you create a VLAN, you can control
traffic flow and ease the administration of moves, adds, and changes
on the network, by eliminating the need to change physical cabling.
On VLAN settings, there are two main settings, VID Table Setting
and Port VLAN Setting.
VID: select the VID group that you set.
When you select VID Table Setting, press “Add new VID” to create
new VID group, from port 01 ~ port 08, select Untag Port, Tag Port or
Not Member for each port. To save the VID group, press “Apply”
button. To remove the selected VID group, select the VID group and
press “Remove the VID” button. To modify the VID group setting,
26