User`s guide

These ports support network speeds of either 10Mbps or 100Mbps,

and can operate in half- and full- duplex transfer modes. These ports

also supports automatic MDI/MDIX crossover detection function

gives true “plug and play” capability, just need to plug-in the network

cable to the hub directly and don’t care if the end node is NIC

(Network Interface Card) or switch and hub.

Note: When the port was set to “Forced Mode”, the Auto

MDI/MDIX will be disabled.

Rear Panel

Figure 4. Rear panel of the Switch

AC Power Connector:

This is a three-pronged connector that supports the power cord. Plug

in the female connector of the provided power cord into this connector,

and the male into a power outlet. Supported input voltages range from

100-240V AC at 50-60Hz.