System information

Configuring the Switch
3-14
3
CLI – Enter the following command.
Setting the Switch’s IP Address (IP Version 4)
This section describes how to configure an IPv4 interface for management access
over the network. This switch supports both IPv4 and IPv6, and can be managed
through either of these address types. For information on configuring the switch with
an IPv6 address, see “Setting the Switch’s IP Address (IP Version 6)” on page 3-17.
The IPv4 address for this stack is obtained via DHCP by default. To manually
configure an address, you need to change the stack’s default settings to values that
are compatible with your network. You may also need to a establish a default
gateway between the stack and management stations that exist on another network
segment.
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Command Attributes
• Management VLAN – ID of the configured VLAN (1-4093). By default, all ports on
the stack are members of VLAN 1. However, the management station can be
attached to a port belonging to any VLAN, as long as that VLAN has been assigned
an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot
Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has
been received from the server. Requests will be broadcast periodically by the
switch for an IP address. (DHCP/BOOTP values can include the IP address,
subnet mask, and default gateway.)
• IP Address – Address of the VLAN to which the management station is attached.
Valid IP addresses consist of four numbers, 0 to 255, separated by periods.
(Default: 0.0.0.0)
• Subnet Mask – This mask identifies the host address bits used for routing to
specific subnets. (Default: 255.0.0.0)
• Gateway IP Address – IP address of the gateway router between the stack and
management stations that exist on other network segments. (Default: 0.0.0.0)
Console#show bridge-ext 4-168
Max support VLAN numbers: 256
Max support VLAN ID: 4093
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#