System information

Command Line Interface
4-16
4
Example
This example shows how to quit a CLI session:
System Management Commands
These commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system information.
Device Designation Commands
This section describes commands used to configure information that uniquely
identifies the switch.
Console#quit
Press ENTER to start session
User Access Verification
Username:
Table 4-6 System Management Commands
Command Group Function Page
Device Designation Configures information that uniquely identifies this switch 4-16
System Status Displays system configuration, active managers, and version information 4-18
Frame Size Enables support for jumbo frames 4-24
File Management Manages code image or ECN330-switch configuration files 4-25
Line Sets communication parameters for the serial port, including baud rate and
console time-out
4-31
Event Logging Controls logging of error messages 4-41
SMTP Alerts Configures SMTP email alerts 4-47
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually 4-50
Table 4-7 Device Designation Commands
Command Function Mode Page
hostname Specifies the host name for the switch GC 4-17
snmp-server contact Sets the system contact string GC 4-57
snmp-server location Sets the system location string GC 4-58
switch renumber Renumbers stack units PE 4-17