System information

Configuring the Switch
3-98
3
• Trunk – Indicates if a port is a member of a trunk. To create trunks and select port
members, see “Creating Trunk Groups” on page 3-99.
Note:
Auto-negotiation must be disabled before you can configure or force the interface
to use the Speed/Duplex Mode or Flow Control options.
Web – Click Port, Port Configuration or Trunk Configuration. Modify the required
interface settings, and click Apply.
Figure 3-55 Port - Port Configuration
CLI – Select the interface, and then enter the required settings.
Console(config)#interface ethernet 1/13 4-120
Console(config-if)#description RD SW#13 4-121
Console(config-if)#shutdown 4-125
.
Console(config-if)#no shutdown
Console(config-if)#no negotiation 4-122
Console(config-if)#speed-duplex 100half 4-121
.
Console(config-if)#negotiation
Console(config-if)#capabilities 100half 4-123
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#exit
Console(config)#interface ethernet 1/21
Console(config-if)#media-type copper-forced 4-125
Console(config-if)#
Note: You cannot set "Sym" and "FC" by Web interface.