User`s guide

FX-16NW

1-2 Rear Panel

Console Port : Connects to the supplied serial cable. The cable is in turn

attached to a terminal(PC) for configuring the switch.

Power Connector : Connects to the supplied power cable.

Power Switch : Turns on/off the power of the switch.

The sticker below is attached on the bottom side of the Switch.

< Model Name >

The product model name of the switching hub.

< Serial No >

A unique product serial number is assigned to each switching hub unit.

Please be sure to include this information in your user registration form.

1-3 Bottom Side

< Port 1-16 >

RJ-45 ports for 100BASE-TX/ 10BASE-T twisted-pair cable connection.

< Uplink Switch >

When the switch is pressed down, Port 12 operates as an uplink port.

< Reset Switch >

Used to reset the FX-16NW Switching Hub. When this switch is pressed

down, all the parameters are reset to their initial (power-up) states.

< Power LED >

This LED lights when the power of the FX-16NW is turned on.

< Link/Act LED >

This LED illuminates when there is a valid data link on the port. The LED

blinks during data transmission/reception.

< 100M LED >

The LED is turned on when a 100Mbps link is established on the port.

< FDX LED >

The LED illuminates when there is a full-duplex link is established on the

port.

< Col. LED >

The LED flashes whenever a collision occurs on the network.

Rear Panel

Bottom Side