User`s guide

4140
FX-16NW
The FX-16NW can be easily monitored through its LED indicators. Please
follow the troubleshooting steps below to solve any problem you may
encounter during installation or implementation of the FX-16NW.
● Cannot communicate with other networking devices
Check whether the Link/Act LED of the port is illuminated or blinking. If
the LED stays out, no link has been established between the networking
device and the Switching Hub.
● Communication fails on a specific port
The port may have been assigned to a VLAN group. Use the
configuration utility to check the VLAN configuration of the switching
hub.
● Cannot communicate even though the Link/Act LED lights up
The port may be assigned to a trunk. Use the configuration utility to
check the Trunking configuration of the Switching Hub.
● Cabling Issues
Please check whether the RJ-45 cable is functional. Replace with another
working cable, and see whether the condition can be improved. (Be sure
to use the correct cable type: for 100BASE-TX, you must use Category 5
cables.)
● Communication fails on a particular port even though it is not assigned to
a VLAN group or trunk
Use another port on the FX-16NW. If a link can be established this way,
the first port is faulty. Please contact your local PCI reseller or PCI
Troubleshooting