User`s guide

[4] Config Sniffer Port Setting

Modifies the current port mirroring settings.

Type “4” at the [Setup>] prompt in the main menu, and press Enter. The

following menu will be displayed. By default no mirror port is configured.

[1]Set Monitor Port

Specifies the port you wish to monitor. Data is copied from this port.

Type “1” after the [Your select>] prompt and press Enter. Then, type a

desired port number at the [Select Monitor Port>] prompt and press Enter.

The terminal application will display the Sniffer port and Monitor port you

just configured.

FX-16NW

Configuring the Port Mirroring Settings

Take 30 seconds to recover if the forwarding delay is set to 10 seconds.

Type “5” at the [Your select>] prompt and press Enter. The current

configuration is displayed. Now, enter a value between 4 and 30 seconds

after [New Forwarding delay>] prompt. The entered value is set to the

current forwarding delay. The default forwarding delay is 15 seconds.

[3] View Spanning Tree Information

Displays the current Spanning Tree Protocol information. Type “3” at the

[Setup>] prompt, and press Enter.

Displaying the Current Spanning Tree Information