User`s guide

FX-16NW

[2] Config spanning Tree Setting

This option allows you to specify the spanning tree protocol settings.

Type “2” at the [Setup>] prompt, and press Enter. The following menu will

be displayed.

[1] Enable/Disable STP

Enables or disables Spanning Tree Protocol.

Type “1” at the [Your select>] prompt and press Enter. The current

configuration is displayed, and you will be asked whether you wish to

change this parameter. If the current setting is “Enable” and if you wish to

disable the protocol, type “y” and press Enter. Similarly, if the current value

is “Disable” and you wish to enable it, type “y” and press Enter. By default,

Spanning Tree Protocol is enabled.

Configuring the Spanning Tree Settings

[2] Set AgeOut Time

This submenu specifies the aging time settings.

Type “2” at the [Your select>] prompt, and press Enter.

The current aging time setting will be displayed. Now, type the new aging

time after the [New Ageout Time 60-65535>] prompt. You can enter a

value between 60 and 65535 seconds. Press Enter to continue.

The default setting is 60 seconds. To disable the aging feature, enter “0”

after the prompt.

[3] EXIT

The current screen returns to the main menu.

Type “3” at the [Your select>] prompt and press Enter.