User`s guide

The transfer mode of the port can be set to any of the following modes:

[1]Auto [2]100Full [3]100Half [4]10Full [5]10Half

Type the desired mode number after the [New Media Mode>] prompt and

press Enter.

Now, you can enable or disable the Flow Control feature. Enter “y” after

the [New Flow Control Mode>] prompt if you wish to enable Flow Control,

or enter “n” to disable this feature. Then press Enter to continue.

To apply these settings to all of the 16 ports, type “y” after the [y/n>]

prompt and press Enter.

By default, all ports are set to [Auto] (Auto-Negotiation) and Flow Control

is enabled on every port.

FX-16NW

[1] Config Switch Setting

In this menu, you can specify the data transfer mode(speed), Flow Control

options and the Aging Time for each of the 16 ports. Type “1” after the

[Setup>] prompt, and press Enter. The following menu will be displayed:

[1] Set Port Condition

This option specifies the data transfer mode and Flow Control settings for

each port.

At the [Your Select>] prompt, type “1” and press Enter.

When the screen says [Which Port do you want to config? (1-16)], type the

number of the port you wish to configure after [Port Num>] and press Enter.

Configuring the Switch