User`s guide

2120
FX-16NW
All the parameters and operational settings of VLAN, Trunking, Spanning
Tree and Port Mirroring features are configured through a terminal
application. This chapter describes the configuration procedure for each of
these four features. To learn how to connect a PC (installed with a terminal
application) to the console port on the Switching Hub, please refer to
Section 2-6.
Once the console port and the terminal are configured properly and a valid
link is established between the two, the following setup menu is displayed.
This menu is the root or starting point of the entire configuration submenus.
Enter the number corresponding to the feature you wish to configure, and
press the Enter key.
3
1
Main Menu
2. Attach the supplied serial cable to the switch and PC The product comes
with a straight RS232 cable with DB-9 male connectors. Please check
whether or not your PC is equipped with a DB-9 male connector. (Most
of computers support a DB-9 male connector.)
Configuring the Switch From a Console
Figure 2-3