User`s guide

1514
FX-16NW
Before proceeding, please take a minute to review the safety guidelines
described in the Safety Instructions above. Also, be sure to follow the
additional guidelines below.
Do not place the product in a damp or wet location.
Always avoid dust and dirt.
Do not install the product in an area exposed to direct sunlight.
Allow some space between the product and the surroundings to facilitate
dissipation of heat generated inside the hub.
Warning:
An accumulation of dust or dirt on the sides of the product or in the air
vents on the rear panel may prevent sufficient heat dissipation. Periodically
inspect these sections of the product and remove any dirt by a vacuum
cleaner, etc.
Always place the product on a level surface (ex. desktop) or in a standard
19”rack.
Installing the Switch on a Level Surface
1. Attach the supplied rubber feet (4 pcs) to the base of the switching hub.
2. Place the product on a level surface such as desktop.
Equipped with these advanced features, switching hubs can provide much
greater network traffic efficiency and expandability compared to ordinary
repeater hubs.
Chapter 2
Installation
2
1
Environmental Requirements
2
2
Installing the Switching Hub
Figure 1-8