System information

2-68
Configuring the Switch
2
Web – Click Priority, IP Precedence Priority. Select a port or trunk from the
Interface field. Select an entry from the IP Precedence Priority Table, enter a value
in the Class of Service Value field, and then click Apply.
Figure 2-45. Selecting IP Precedence Priority
* Mapping specific values for IP Precedence is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
CLI – The following example globally enables IP Precedence service on the switch,
maps IP Precedence value 1 to CoS value 0 on port 5, and then displays all the IP
Precedence settings.
* Mapping specific values for IP Precedence is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip precedence 3-117
Console(config)#interface ethernet 1/5
Console(config-if)#map ip precedence 1 cos 0 3-117
Console(config-if)#end
Console#show map ip precedence ethernet 1/5 3-121
Precedence mapping status: disabled
Port Precedence COS
--------- ---------- ---
Eth 1/ 5 0 0
Eth 1/ 5 1 0
Eth 1/ 5 2 2
Eth 1/ 5 3 3
Eth 1/ 5 4 4
Eth 1/ 5 5 5
Eth 1/ 5 6 6
Eth 1/ 5 7 7
Console#