System information

3-131
Authentication Commands
3
radius-server host
Use this command to specify the RADIUS server. Use the no form to restore the
default.
Syntax
radius-server host host_ip_address
no radius-server host
host_ip_address - IP address of server.
Default Setting
10.1.0.1
Command Mode
Global Configuration
Example
radius-server port
Use this command to set the RADIUS server network port. Use the no form to
restore the default.
Syntax
radius-server port port_number
no radius-server port
port_number - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)
Default Setting
1812
Table 3-45. RADIUS Client Commands
Command Function Mode Page
radius-server host Specifies the RADIUS server GC 3-131
radius-server port Sets the RADIUS server network port GC 3-131
radius-server key Sets the RADIUS encryption key GC 3-132
radius-server retransmit Sets the number of retries GC 3-132
radius-server timeout Sets the interval between sending authentication requests GC 3-133
show radius-server Shows the current RADIUS settings PE 3-133
Console(config)#radius-server host 192.168.1.25
Console(config)#