System information

3-126
Command Line Interface
3
channel-group
Use this command to add a port to a trunk. Use the no form to remove a port from a
trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-6)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
•Use no channel-group to remove a port group from a trunk.
•Use no interfaces port-channel to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11.
lacp
Use this command to enable 802.3ad Link Aggregation Control Protocol (LACP) for
the current interface. Use the no form to disable it.
Syntax
lacp
no lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#