System information

3-109
Multicast Filtering Commands
3
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (3-103)
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
Use this command to statically configure a multicast router port. Use the no form to
remove the configuration.
Syntax
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Console(config)#ip igmp snooping query-time-out 300
Console(config)#
Table 3-33. Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter
Adds a multicast router port GC 3-109
show ip igmp snooping
mrouter
Shows multicast router ports PE 3-110