System information

3-66
Command Line Interface
3
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 25.
Console#show interfaces switchport ethernet 1/22
Information of Eth 1/22
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Private-vlan mode: NONE
Private-vlan host-association: NONE
Private-vlan mapping: NONE
Console#
Table 3-21. Interfaces Switchport Statistics
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 3-62).
Lacp status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 3-126).
VLAN membership mode Indicates membership mode as Trunk or Hybrid (page 3-86).
Ingress rule Shows if ingress filtering is enabled or disabled (page 3-87).
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only
(page 3-87).
Native VLAN Indicates the default Port VLAN ID (page 3-88).
Priority for untagged traffic Indicates the default priority for untagged frames (page 3-111).
Gvrp status Shows if GARP VLAN Registration Protocol is enabled or disabled (page 3-97).
Allowed Vlan Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 3-89).
Forbidden Vlan Shows the VLANs this interface can not dynamically join via GVRP (page 3-90).