System information

3-4
Command Line Interface
3
display a list of valid keywords for a specific command. For example, the command
“show ?” displays a list of possible show commands:
The command “show interfaces ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match the
initial letters are provided. (Remember not to leave a space between the command
and question mark.) For example “s?” shows all the keywords starting with “s.”
Console#show ?
bridge-ext Bridge extend information
calendar Date information
dot1x Show 802.1x content
garp Garp property
gvrp Show gvrp information of interface
history Information of history
interfaces Information of interfaces
ip IP information
line TTY line information
logging Show the contents of logging buffers
mac-address-table Set configuration of the address table
map Map priority
port Characteristics of the port
queue Information of priority queue
radius-server Radius server information
running-config The system configuration of running
snmp SNMP statistics
spanning-tree Specify spanning-tree
startup-config The system configuration of starting up
system Information of system
tacacs-server Login by tacacs server
users Display information about terminal lines
version System hardware and software status
vlan Switch VLAN Virtual Interface
Console#show
Console>show interfaces ?
counters Information of interfaces counters
status Information of interfaces status
switchport Information of interfaces switchport
Console#show s?
snmp spanning-tree startup-config system