System information

2-74
Configuring the Switch
2
Dynamically Configuring a Trunk
Command Usage
• To avoid creating a loop in the network, be sure you enable LACP before
connecting the ports, and also disconnect the ports before disabling LACP.
• If the target switch has also enabled LACP on the connected ports, the trunk will
be activated automatically.
• A trunk formed with another switch using LACP will automatically be assigned the
next available trunk ID.
• If more than four ports attached to the same target switch have LACP enabled, the
additional ports will be placed in standby mode, and will only be enabled if one of
the active links fails.
• All ports on both ends of an LACP trunk must be configured for full duplex, either
by forced mode or auto-negotiation.
Web – Click Trunk, LACP Configuration. Select any of the switch ports from the
scroll-down port list and click Add. After you have completed adding ports to the
member list, click Apply.
Figure 2-49. LACP Configuration