Installation guide

About the Switch
1-8
disabled.
To connect a device to an SFP port, do the following:
1. Use your cabling requirements to select an appropriate SFP transceiver type.
2. Insert the SFP transceiver (sold separately) into an SFP slot. The slot’s LED
indicator turns on to confirm that it is correctly installed.
The 1000BASE-T RJ-45 ports support automatic MDI/MDI-X operation, so you can
use straight-through cables for all network connections to PCs or servers, or to other
switches or hubs. (See “10BASE-T/100BASE-TX Pin Assignments” on page B-2.)
Power Supply Receptacle
The power receptacle is located on the rear panel of the switch. The standard power
receptacle is for the AC power cord.
Figure 1-12. Power Supply Receptacle
100-240V~
50/60Hz, 2A