Installation guide

About the Switch
1-4
System Status LEDs
Figure 1-3. System Status LEDs
System Status LEDs
LED Condition Status
PWR On Green The unit’s internal power supply is operating normally.
On Amber The unit’s internal power supply has failed.
Off The unit has no power connected.
Diag On Green The system diagnostic test has completed successfully.
Flashing Green The system diagnostic test is in progress.
On Amber The system diagnostic test has detected a fault.
Link N/A This indicator is not currently implemented.
Duplex N/A This indicator is not currently implemented.
Stack
Flashing Amber An initial state of stacking configuration upon powering on.
Green This switch is acting as the master unit in the stack.
Amber This switch is acting as a slave unit in the stack.
Flashing Green
When the user enters the light unit command in the CLI,
the unit ID of each switch in the stack will be displayed by
port LEDs 1 to 8.
Link
Duplex
M1
M2
PWR
Diag
Stack
Module 1
RPU