User's Manual

http://www.sapido.com.tw 97
USER MANUA
L
V1.0
Chapter 8 Q & A
8.1 Installation
1. Q: Where is the XDSL Router installed on the network?
A: In a typical environment, the Router is installed between the XDSL line and the LAN.
Plug the XDSL Router into the XDSL line on the wall and Ethernet port on the Hub
(switch or computer).
2. Q: Why does the throughput seem slow?
A: To achieve maximum throughput, verify that your cable doesn’t exceed 100 meter. If
you have to do so, we advise you to purchase a bridge to place it in the middle of the
route in order to keep the quality of transmitting signal. Out of this condition you
would better test something else.
z Verify network traffic does not exceed 37% of bandwidth.
z Check to see that the network does not exceed 10 broadcast messages per
second.
z Verify network topology and configuration.
8.2 LED
1. Why doesn’t PCI022_MZK-KR150NUS Broadband Router power up?
A: Check if the output voltage is suitable, or check if the power supply is out of order.
2. The Internet browser still cannot find or connect to PCI022_MZK-KR150NUS
Broadband Router after verifying the IP address and LAN cable, the changes
cannot be made, or password is lost.
A: In case PCI022_MZK-KR150NUS Broadband Router is inaccessible, you can try to
restore its factory default settings. Please press the “Reset” button and keep it
pressed for over 10 seconds and the light of STATUS will vanish. The LEDs will flash
again when reset is successful.
3. Why does PCI022_MZK-KR150NUS Broadband Router shut down unexpectedly?
A: Re-plug your power adapter. Then, check the STATUS indicator; if it is off, the
internal flash memory is damaged. For more help, please contact with your provider.