User's Manual

7
6. Set your wireless securities settings, when it completed, click the “OK”
button. Select the Network Authentication and Data encryption to set the
encryption type.
- If you have WEP, typically you select the format and enter your WEP key
below the Data encryption.
- If you have WPA-PSK or WPA2-PSK, typically you only enter your key in
the “Network Key” and type again to confirm it.
- If you have 802.1x configure, typically you only configure your setting
in 802.1x configure column.
7. After connected to wireless network, utility will back to “General” page
and show the wireless network status. Once the wireless network
connected successfully, the Network Address will show the dongle has
gotten the IP address from DHCP.