User Manual

HDMI / Video Wall over IP with PoE

IHD-200PT / IHD-200PR

3. You also could use HDMI splitter (matrix) to do the sources convert.

As you see, two sources connect to the input of HDMI matrix, and output to Tx, and

then Tx and Rx all connect to the switch.

In this case, we use the HDMI matrix controller to select the source, of which one

should be transmitted.

Q6: Users encounter no screen display in computer connection.

1. Make sure the device cables are correctly and firmly attached.

2. Set your display device’s (TV, monitor, etc.) input source as HDMI.

3. Check the PC BIOS configuration about the video output setting.

4. Connect your computer to the HDMI Display DIRECTLY to check if the video

signal gets through.

5. Slide the Rotary DIP Switch to the correct position.

6. Inappropriate EDID data. Apply EDID Copy to your display.

Please refer to the 4.1 EDID Configurations.

7. Please reboot or disconnect and connect again.

Q7: Do I have to use the same screen resolution to set video wall?

We suggest user to use the same screen resolution to set video wall so that user can

get the best performance. If user uses the different screen resolution please try

“EDID copy” to solve no display issue. (But video extender accepted.)

Q8: What’s the maximum limit distance between input video source and

output video?