User Manual

11
■GigabitFiberInterface
LED Color Function
Fiber
LNK/ACT
Green
Lightstoindicatethattheberopticportis
successfully connecting to the network at 1000Mbps.
Blinkstoindicatetheberopticportisreceivingor
sending data.
Amber
Lightstoindicatethattheberopticportis
successfully connecting to the network at 100Mbps.
Blinkstoindicatetheberopticportisreceivingor
sending data.
3.3 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial PoE++
Media Converter is used for two 12-56V DC redundant power inputs. Please
follow the steps below to insert the power wire.
Caution
When performing any of the procedures like inserting the wires
or tightening the wire-clamp screws, make sure the power is
OFF to prevent from getting an electric shock.
1. Insert positive and negative DC power wires into contacts 1 and 2 for
POWER 1, or 5 and 6 for Power 2.
V1+ V2+
PWR1
PWR2Alarm
DC Input:
12-56V , 6A max.
Max. Fault Alarm Loading: 24V, 1A
1 2 3 4 5 6