Datasheet

ManualsBrandsPlanet ManualsAutomationPoE Switch, Managed, 1Gbps, 270W, RJ45 Ports 8, PoE Ports 8

IGS-10020HPT

Industrial 8-Port 10/100/1000T 802.3at PoE + 2-Port 100/1000X

SFP Managed Switch with Wide Operating Temperature

Environmentally Hardened Design

The Industrial 8-Port Gigabit 802.3at PoE Switch, IGS-10020HPT is equipped with rugged

IP30 metal case for stable operation in heavy Industrial demanding environments. With

IP30 industrial case protection, the IGS-10020HPT provides a high level of immunity

against electromagnetic interference and heavy electrical surges which are usually found

on plant floors or in curb side traffic control cabinets. Being able to operate under wide

temperature range from -40 to 75 Degree C, the IGS-10020HPT can be placed in almost

any difcult environment. The IGS-10020HPT also allows either DIN rail or wall mounting

for efcient use of cabinet space.

Redundant Ring, Fast Recovery for Surveillance System

The IGS-10020HPT supports redundant ring technology and features strong rapid self-

recovery capability to prevent interruptions and external intrusions. It incorporates

advanced Redundant Ringtechnology, Spanning Tree Protocol (802.1w RSTP), and

redundant power supply system into customer’s industrial automation network to enhance

system reliability and uptime in harsh factory environments. The IGS-10020HPT also

protects customer’s industrial network connectivity with switching recovery capability that is

used for implementing fault tolerant ring and mesh network architectures. If the Industrial

network was interrupted accidentally, the fault recovery times could beless than 50ms to

quickly bring the network back to normal operation.

Physical Port

• 8-Port 10/100/1000Base-T Gigabit Ethernet RJ-45

with IEEE 802.3af / 802.3at PoE Injector

• 2 100/1000Base-X mini-GBIC/SFP slots, SFP type

auto detection

• One RJ-45 console interface for basic management

and setup

Power over Ethernet

• Complies with IEEE 802.3af / IEEE 802.3at Power

over Ethernet / End-Span PSE

• Up to 8 IEEE 802.3af / 802.3at devices powered

• Supports PoE Power up to 30.8 Watts for each PoE

ports

• Auto detect powered device (PD)

• Circuit protection prevent power interference

between ports

• Remote power feeding up to 100m

• PoE Management features

− IEEE 802.3af and IEEE 802.3at mode switch control

− Total PoE power budget control

− Per port PoE function enable/disable

− PoE Admin-mode control

− PoE Port Power feeding priority

− Per PoE port power limit

− PD classication detection

− Temperature Threshold Control

− PoE Usage Threshold Control

− PD Alive Check

− PoE schedule

Industrial Case / Installation

• IP30 Aluminum metal case protection

• DIN Rail and Wall Mount Design

• 48V DC, redundant power with polarity reverse

protect function

• Supports EFT protection 6000 VDC for power line

• Supports 6000 VDC Ethernet ESD protection

• -40 to 75 Degree C operating temperature

Summary of content (11 pages)

PAGE 1
IGS-10020HPT Industrial 8-Port 10/100/1000T 802.3at PoE + 2-Port 100/1000X SFP Managed Switch with Wide Operating Temperature Physical Port • 8-Port 10/100/1000Base-T Gigabit Ethernet RJ-45 with IEEE 802.3af / 802.3at PoE Injector • 2 100/1000Base-X mini-GBIC/SFP slots, SFP type auto detection • One RJ-45 console interface for basic management and setup Power over Ethernet • Complies with IEEE 802.3af / IEEE 802.
PAGE 2
IGS-10020HPT ERPS Ring for Video Transmission Redundancy PoE Outdoor PoE IP Camera PoE Digital Input / Digital Output Outdoor PoE IP Camera • 2 Digital Input (DI) PoE • 2 Digital Output (DO) PoE 1000 • Integrate sensors into auto alarm system IGS-10020HPT • Transfer alarm to IP network via email and SNNP trap Traffic Control Center 1000 IGS-10020HPT Outdoor PoE IP Camera PoE PoE Layer 2 Features • Prevents packet loss with back pressure (Half-Duplex) Recovery time < 50 ms 1000 1000 Netw
PAGE 3
IGS-10020HPT Intelligent Alive Check for Powered Device The IGS-10020HPT PoE Switch can be configured to monitor connected PD’s status in real-time via ping action. Once the PD stops working and no response, the IGS10020HPT will recycle the PoE port power and bring the PD back to work. It also greatly enhances the reliability owing that the PoE port will reset the PD power and thus reduce administrator’s management burden.
PAGE 4
IGS-10020HPT Digital Input and Digital Output for external Alarm The IGS-10020HPT supports Digital Input, and Digital Output on its front panel. This external alarm enables users to use Digital Input to detect, log external device status (such as door intrusion detector ), and send event alarm to the administrators. The Digital Output could be used to alarm the administrators if the IGS-10020HPT port link down, link up or power failure.
PAGE 5
IGS-10020HPT Powerful Security The IGS-10020HPT offers comprehensive Layer 2 to Layer 4 Access Control List (ACL) for enforcing security to the edge. It can be used to restrict network access by denying packets based on source and destination IP address, TCP/UDP ports or defined typical network applications. Its protection mechanism also comprises of 802.1x Port-Based and MAC-Based user and device authentication.
PAGE 6
IGS-10020HPT Application Industrial Area Department / Workgroup PoE Switch Providing up to 8 PoE+, in-line power interface, the IGS-10020HPT can easily build a power central-controlled IP phone system, IP camera system, or wireless AP group for Industrial network. For instance, 8 PoE IP cameras or Wireless Access Points can be easily installed around the corner in the industrial environment for surveillance demands or for a wireless roaming network.
PAGE 7
IGS-10020HPT Specification Product IGS-10020HPT Hardware Specification Copper Ports 8 10/ 100/1000Base-T RJ-45 Auto-MDI/MDI-X ports SFP/mini-GBIC Slots 2 1000Base-SX/LX/BX SFP interfaces (Port-9 and Port-10) Compatible with 100Base-FX SFP Console 1 x RJ-45-to-RS-232 serial port (115200, 8, N, 1) Switch Architecture Store-and-Forward Switch Fabric 20Gbps / non-blocking Throughput (packet per second) 14.
PAGE 8
IGS-10020HPT Power Pin Assignment 1/2(+), 3/6(-) PoE Power Budget 270W maximum (depends on power input) Max. number of Class 2 PD 8 Max. number of Class 3 PD 8 Max.
PAGE 9
IGS-10020HPT Standards Conformance Regulation Compliance FCC Part 15 Class A, CE Stability Testing IEC60068-2-32 (Free fall) IEC60068-2-27 (Shock) IEC60068-2-6 (Vibration) Standards Compliance IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX/100Base-FX IEEE 802.3z Gigabit SX/LX IEEE 802.3ab Gigabit 1000T IEEE 802.3x Flow Control and Back pressure IEEE 802.3ad Port trunk with LACP IEEE 802.1D Spanning tree protocol IEEE 802.1w Rapid spanning tree protocol IEEE 802.1s Multiple spanning tree protocol IEEE 802.
PAGE 10
IGS-10020HPT Ordering Information IGS-10020HPT Industrial 8-Port 10/100/1000T 802.
PAGE 11
IGS-10020HPT Available PD for IGS-10020HPT ICA-2200 Full HD PoE Box IP Camera ICA-2500 5 Mega-Pixel PoE Box IP Camera ICA-3250V Full HD Outdoor IR PoE IP Camera ICA-3350V 3 Mega-Pixel Vari-Focal Bullet IR IP Camera ICA-4200V Full HD 20M IR Vari-Focal Dome IP Camera ICA-5350V 3 Mega-Pixel Vandal Proof IR IP Camera ICA-8350 3 Mega-Pixel Vandal Proof Fisheye IP Camera ICA-HM126 H.264 Full HD Box IP Camera ICA-HM127 3 Mega-Pixel H.264 Box IP Camera ICA-HM131 H.